01Torsion
Torsion springs
Mounted on a shaft above the opening and turning as the door moves. The usual setup on a newer door.
- Sized to the door's weight
- Wound to tension
- Both springs on two-spring doors
- Shaft bearings checked
Garage door spring replacement in Richmond Hill and the GTA, with the spring sized to this door's weight and the cables checked in the same visit.

What’s included
A spring is chosen for the door it lifts. Torsion or extension decides the parts and how the job is done.
01Torsion
Mounted on a shaft above the opening and turning as the door moves. The usual setup on a newer door.
02Extension
Run along the horizontal tracks on both sides and stretch as the door closes. Each should carry a safety cable.
03Cables
A spring that lets go often takes a cable with it. Both cables are replaced in almost every case, and the drums are checked.
04Balance
A spring is right when the door stays put halfway up with the opener disconnected. Every job ends with that test.
How it runs
Most single-door spring replacements take about an hour. The order of the steps is what keeps the job safe.

On arrival
Wire size, length and wind direction are taken from it and matched to the door.
Unwinding
The old spring is let down under control with winding bars, never freed all at once.
Once slack
Cables and drums change only now. The new spring is fitted and wound last.
Last check
With the opener disconnected, the door is lifted to halfway. It has to stay there.
Reasons
A wound spring stores a great deal of energy, so the job is in the measuring and the winding more than the part.
The spring is matched to this door's weight, never guessed. A wrong size leaves the door unbalanced and wears the opener, cables and rollers.
The spring that survived has done the same cycles as the one that broke, so it is close behind. Both are replaced.
An old extension door may have no safety cable through its springs. Without one, a spring that breaks can whip across the garage, so it is the first check.
An opener guides a balanced door and does not lift it. A spring is judged by the door holding its place, not by the remote working.
Reviews
From the reviews homeowners left on our Google listing: cut for length, never reworded.
Rated 4.9 out of 5 from 70 reviews on Google (opens Google Maps)After years of dents and damage from hockey pucks, our new garage door looks amazing!!
I’m very happy with the work done on my front door and garage door. … Both doors look amazing …
Everyone else told me I’d be waiting anywhere from 6 weeks to 4 months just to get a door delivered and installed.
My garage spring and cables snapped on a Sunday afternoon, Moe was able to swing by the next morning …
Great Service by Moe, very clean job, on time and no surprises.
It completely changed the look of my home and has already received so many compliments.
The work was done in 5 hours and they cleaned up after themselves leaving no trace of my old garage door and front door.
I called Moe he was here in the same hour and we got our new doors in two days
He didn’t just fix the immediate problem … made sure the door was running smoother and quieter than before.
We were presented with multiple options and given the pros and cons of each.
… replacing my destroyed garage door for a beautiful modern style door.
Replaced my front door and garage door with a remote. … the finished work looks amazing.
I had a quote within a day … and the new door installed by that weekend.
Garage door spring was broken. Moe was able to come out the next day and fit it.
Moe takes the time to get to know what your needs are and has affordable recommendations.
Moe did an excellent job replacing our old, worn down garage door with a beautiful, heavy duty white one.
… he was here the next day and we had our garage doors and front doors done within one week.
The whole process was seamless and I couldn’t believe how fast the job was completed without any hiccups.
… came on short notice to take a look. He quickly diagnosed the problem and had it fixed in no time.
They were super on time, super efficient, and the price was dead on.
Projects
Real jobs on our customers’ houses, recreated from the photos we took: the door we took down, and the one we hung in its place.
A two-car door, dented end to end.

Every section of the old door was dented, and the middle had torn open. We hung a flush steel door in the same opening, charcoal to sit with the dark siding, under the same basketball hoop.
Gallery
Eighteen garage and front door styles, each one modelled on a door we’ve hung.
Service area
Every town we serve, by the drive from our shop in Richmond Hill. The nearest are on top.
FAQ
What homeowners ask us about garage door spring repair and replacement, and about the door in general.
Not here? Ask us for a free estimate.
There is no honest single number, and anyone who gives you one over the phone is guessing. The price depends on the size of the opening, single or double, the material and insulation, the windows and hardware, and whether the existing tracks, springs and opener can stay. Modern Empire Doors gives you a real number quickly instead: text a photo of the door from outside and one from inside the garage to (647) 323-1826. The inside shot shows the tracks, springs and opener, which is where most of the difference in price lives. Estimates are free.
Two photos and your address. Take one of the door from outside, and one from inside the garage with the door closed, so we can see the tracks, the springs above the opening and the opener. Text both to (647) 323-1826. For most doors that is enough to price the job without anyone coming out first, and the estimate is free.
Most standard replacements are done in a single visit. The old door comes down, the new one goes up on its tracks and springs, and it is balanced and tested before we leave. Doors with more complicated framing, a change of size, or a new opener at the same time take longer. We tell you what to expect for your door when we quote it, not after we arrive, so you can plan the day around it.
Not always. Whether the opener can stay is part of the quote. The springs are sized to the new door, so a working opener is not asked to lift more weight; what matters is its age and condition. An opener from before about 1993 may use a fixed code that cheap equipment can copy, and a new door is a good moment to change it. A loud chain drive under a bedroom is the other reason people switch, usually to a quieter belt drive. We tell you which applies before you decide.
Our replacement doors are made in Canada and carry a lifetime warranty. Built for Canadian winters is not a slogan here: a door that seals properly in February is a different product from one that does not, and the difference shows up as cold air, noise and a bottom seal frozen to the floor. If you want the details for a particular door, ask when we quote it and we will go through them with you.
The cycle rating you choose moves it most, then the wire size the door needs, torsion kit or extension pair, and one spring or two. You get the price before any work begins, and the estimate is free.
No, this is a repair we ask owners not to try. A torsion spring on a double door holds several hundred pounds of stored energy, and without winding bars and the right technique it lets go all at once. A spring wrong for the door's weight is the other risk: the door runs, but unbalanced.
It depends on the cycle rating and how often the door is used. A standard spring is often rated around 10,000 cycles, about seven years at four openings a day, and cold winters or dry coils shorten that. Replacing a tired spring on a planned visit is calmer than a broken one on a January morning.
Often, and both together. Both cables go in almost every case, and the drums, bottom brackets and pulleys are checked while the door is apart. You hear what was found, and the price, before any extra work.
Replacing a spring leaves the opening exactly as it is. If you want certainty for your address, ask us when we give the estimate.
People also ask
The garage door questions people type into Google, answered in a few lines each. Search for yours, or pick a part of the door.
Search 24 answers from Modern Empire Doors
24 answers
Torsion springs sit on a shaft above the opening and turn as the door moves. Extension springs run along the horizontal tracks and stretch as the door closes, and each should carry a safety cable. Torsion is the more common modern setup.
Asked next
Yes, if the door has two. The second spring has worked as hard as the one that broke, and a new spring beside a tired one leaves the door out of balance. Both are measured to the door and fitted in the same visit.
Asked next
Most often a spring has broken. The opener is built to guide a balanced door, so with a spring gone it lifts a little, reads the weight as an obstruction and stops. A frayed cable or a binding track can do the same.
Asked next
Close the door, pull the red cord to disconnect the opener, and lift the door by hand to about halfway. A balanced door moves smoothly and stays where you leave it. If it slides down the springs are tired, and if it rises the tension is too high. Try it only if the springs and cables are intact.
Asked next
Look near the bottom brackets, where a cable usually fails first, for broken strands, rust or a section that looks flattened or thinner. With the door closed the cables are under tension, so look but do not touch. A few broken strands mean the rest are carrying more.
Asked next
Most often it is the safety sensors. If anything breaks the invisible beam between the two photo eyes, about six inches off the floor, the door starts down and reverses. Clear the path, wipe both lenses and check that both sensor lights are steady. If the door touches the floor and then goes back up, the close limit on the opener has drifted.
Asked next
The guide
What the visit does, how a spring fails, what moves its price and how long it lasts.
A broken spring is replaced, not mended in place. Until it is, the opener drags the full weight of the door and can burn out, and the door itself can fall, so stop using it.
On a torsion system the winding is done with proper winding bars. That is why we ask owners not to try it, and why the visit ends with the door held at halfway rather than with a test of the remote.
Most of the spring is decided by the door. Its weight sets the wire size and length, and the wind direction follows the shaft. What is left to you is the cycle rating: a standard spring suits a door opened a few times a day, and a higher rating suits one used far more often.
On a door with two springs, ask for both to be replaced. The one that survived has done the same number of openings as the one that broke, and a new spring beside a tired one leaves the door out of balance.
Most cables fail from rust at the bottom bracket, where snowmelt and road salt sit against the floor, or from rubbing on a worn drum, a bent bracket or a track edge. A broken spring is the third cause, and it can send a cable slack and off its drum.
Keeping the bottom of the door clean and dry helps the next set last longer. Where a cable has already started to fray, the other one has worked under the same conditions.
The cycle rating you choose, the wire size the door's weight calls for, torsion kit or extension pair, and one spring or two are what set the figure. A higher-cycle spring costs more up front and lasts markedly longer.
That is usually the better buy for a door used several times a day. The estimate is free, and the price is given before the work starts.
Free estimates · Repairs any hour
A photo of the springs from inside the garage and one of the door from outside are enough for a free estimate, at any hour. Book below.
Rated 4.9 out of 5 from 70 Google reviews.
Book a free estimate